Repair holes and tears in your safety pool cover with these Safety Cover Repair Patches, a self adhesive safety cover patch kit.

Each kit contains three 8.5" x 3.5" self adhesive repair patches that can be cut into multiple smaller patches. Patches are compatible with Cantar, NorthFlo, GLI and Latham safety covers.

Instructions:

1. 1) Thoroughly clean area on both sides of the cover that will be patched. It is important to make sure the area is completely dry before applying the patch.
2. 2) Trim any loose threads around the hole so the patch will lay flat.
3. 3) Cut the patch so it will overlap the hole by 1” all the way around and round off all corners on the patch.
4. 4) Lay cover on a flat solid surface.
5. 5) Remove backing from self-adhesive patch and apply to the cover by pressing firmly and work across to remove wrinkles and air pockets.

For best results, apply a second patch to the backside of the cover by repeating the steps above.

WARNING: Holes and tears greater than 3” should NOT be patched. For use with Solid Safety Covers of the same colour only.